INLET JAGUAR

PIPES D'ADMISSIONS JAGUAR - INLET MANIFOLDS JAGUAR

Linkage inc. Carried on 3 rose joints

3.8&4.2-6 cyl. Engines, inc. Manifold with water gallery, thermostat housing & stud fitting kit

3 X 40/45 DCOE or
3 X 40/45 DHLA

Linkage on rose joints & cast pillar for thorttle quadrant inc.

V12 pair of manifolds (1 piece per bank) plus cast, finned carburettor tops, ram pipes and stud fixing kit

6 X 40 IDF
or
6 X 40 DRLA

V12 pair of manifolds only & stud fixing kit

6 X 40 IDF or
6 X 40 DRLA

Linkage on rose joints & cast pillar for thorttle quadrant inc.

V12 pair of manifolds (1 piece per bank) plus cast, finned carburettor tops, ram pipes and stud fixing kit

6 X 45 IDF
or
6 X 45 DRLA

V12 pair of manifolds only & stud fixing kit

6 X 45 IDF or
6 X 45 DRLA

** Voir page"COMMANDE" - See on page"LINKAGE"

NOTES: Les pipes d'admissions pour carburateurs Weber DCOE et Dellorto DHLA sont identiques
             La plupart des pipes d'admissions ne comportent pas la prise pour le servo frein (nécessite le montage)
             Les pipes d'admissions sont fournies avec le nécessaire de montage (goujons, 'O'ring, rondelles et écrous)

NOTES:Weber DCOE type manifolds are also suitable for Dellorto DHLA carburettors
             Most of the manifolds do not have a servo vacuum takeoff, but if required there is normally a suitable boss wich can
             be drilled and tapped
              All manifolds are supplied with fitting kit (studs, nuts, 'O'rings, washers)